Using the saw is not necessarily difficult, but if you want to make the best cuts, you need to learn how to work with the saw. The differences between the different models and brands of saw blades lie in their ability to produce quality saws. However, regardless of the quality of the saw, it is very important that you do your best to get the most out of your saw.
Some carpenters spend money to buy quality saws, but they can’t use them for charity. If you have a notch, there are several things you have to do to maximize the use of the notch and eventually get the best notch. Here are some tips to get you started:
- Levelling for mitre saw blade
Many saws come standard with a saw blade of 24 to 40 teeth. They do not allow clean cuts, but can be used to saw the frame of wood planks and decking when softness is not so important. However, if you want to make an impressive, impeccable cut in the wood, you need to raise your saw blade to a level that guarantees a perfect cut.
These kinds of knives tend to have small negative cutting angles. They are also available with different numbers of teeth. The number of teeth used depends on the size of your cam saw. If you are using a 10 inch saw, you should choose 80 saw blades, and if you are using a 12 inch model, 100 saw blades should be the right choice for you.
- Knowing the angle of your knife
The performance of your saw also depends to some extent on the angle of the saw blade hook. The angle of the hook refers to the direction in which the teeth are pointing. The neutral angle of the hook 0 has teeth with protruding edges. With the positive hook angle, the sharp edges are facing forward, while with the negative hook angle, the edges of the blades are facing backward. This is called negative or positive raking with a knife.
The higher the positive angle, the coarser the cut. The lower the negative angle, the smoother the cut. Sheets with a suspension angle between 10 and -5 degrees are more recommended than any other type outside these two measurements. Positive blades with a hook angle of more than 10 degrees cut aggressively and therefore may not produce the best cuts or accuracy for anything other than framing. On the other hand, negative blades below -5 degrees are very slow and soft on the workpiece. This way they only give a bad cut if you work with normal wood.
- Fuse burned out
It is advisable to install a spare table and a fence made of solid boards, plywood or MDF. This provides instant play-free support to guide the knife against a tear when leaving the cut.
There is no doubt that the support between the zero-gap plate supplied with the tool and the plate you made will decrease after making two different cuts with different settings. This guarantees the constant support of the other party. So it would be good if you put a piece of the guard in that direction. The support table and fence need to be replaced when they are very old.
- Only lift when the blade is still.
After sawing with the saw, it is advisable to first lift the saw if the blade is not fully rotating. If you lift the knife before it stops, there is a risk that the rotating knife will catch the cut and pull dangerously through the workpiece at high speed. It can also engrave the end of a piece and need a new cut.
- Sneaking in cuts
It is possible to bend the mitre saw blades when cutting hardwood. The best way to prevent this is to proceed in two steps. Start the first cut about 1/16 inch from the waste side of the cutting line. Then cross the line. This last incision should be about twice as wide as normal, but square and sharper.
miter saw hacks,miter saw tearout,how to cut a long piece of wood with a miter saw,miter saw fence,miter saw fence upgrade,miter saw table,miter saw tips and tricks,miter saw projects
Disclosure: We are a professional review company & our reviews are not biased towards any of the products we review. We test each product thoroughly and give marks to only the very best that is given by our author. We are very independently owned & the opinions expressed here are our own. However, if you purchase anything after clicking the links present in the articles then we get some commissions for it which help maintaining the websites expenses like servers, security etc.